Failsafe Rule

"In the event of loss of signal the failsafe must be set so that, after a maximum of 3 seconds the engine will go to idle or shut down. The use
of idle as the failsafe setting must be authorised by the event organiser. The event organiser may also specify a shorter delay time."

 

Under the new JMA rules, when a receiver goes into failsafe the engine must go to idle, then within 3 seconds (if the RX has not gone out of failsafe) the engine has to shut down. The JetCat ECU can do this already, its just the other types that need additional help.
 

This Fuel Cut Off Relay Switch has been designed to compliment existing Gas Turbine installations that feature a solenoid fuel valve with operating voltage range of between 4-6v.

 

Fuel Cut Off Relay Switch about £25.00 inc shipping from Intairco.

How to setup the Fuel Cut Off Relay Switch.

Simple to install and connects to an independent channel on the receiver to enable engine shut down regardless of ECU condition.